Commands listed in alphabetical order
Arguments
<NR1>
is the number of B trigger events, which can range from 1 to 65,471.
Examples
TRIGGER:B:EVENTS:COUNT 4
sets the number of B trigger events to four.
TRIGGER:B:EVENTS:COUNT?
might return
:TRIGGER:B:EVENTS:COUNT 2
,
indicating that two events must occur after the A trigger before the B trigger
can occur.
TRIGger:B:RESET (No Query Form)
This command sets the B reset trigger level to 50%.
Group
Trigger
Syntax
TRIGger:B:RESET
SETLevel
Arguments
SETLevel
sets the B reset trigger level to 50%.
Examples
TRIGger:B:RESET SETLevel
sets the B reset trigger level to 50%.
TRIGger:B:RESET:EDGE:COUPling
Sets or queries the trigger coupling for a sequential edge trigger reset when the
Source is set to an analog channel.
Group
Trigger
Syntax
TRIGger:B:RESET:EDGE:COUPling {DC|HFRej|LFRej|NOISErej}
TRIGger:B:RESET:EDGE:COUPling?
Related Commands
Arguments
DC
selects
DC
trigger coupling.
HFRej
selects high frequency low sensitivity.
LFRej
selects low frequency low sensitivity.
NOISErej
selects
DC
low sensitivity.
MSO54, MSO56, MSO58, MSO58LP Programmer
2-879
Summary of Contents for MSO54
