Service Manual
2-25
Installing the Printer and Drivers
2
Configuration page
To provide further diagnostic information, the printer can print a configuration
page. The configuration page lists the values that the printer stores in its
NVRAM as well as those of an installed network card’s NVRAM. These values
can be informative when troubleshooting the printer, particularly networked
operations. To print a configuration page, while the printer is powered-up and
idle, scroll through the front panel menu and select Configuration Page from the
Help pages
menu. Refer to the Section 9 topic, “Printing the configuration
page” on page 9-4.
The configuration page gives the following information:
■
General information about the printer, such as print count, the
assigned name, Ethernet address, the authorization code (if loaded),
timeouts, number of fonts, and total memory
■
Color settings such as Vivid Color
■
Serial port settings (if installed)
■
Parallel port settings
■
LocalTalk port settings (if installed)
■
EtherTalk settings (if installed)
■
TCP/IP settings (if installed)
■
Novell NetWare settings (if installed)
Table 2-1 Configuration page settings
Parameter
Description
Saved
in
NVRAM
Default
Limits or alternate choices
Printer name
The current name of the printer as
seen on a network.
yes
Phaser 600
Any name defined by the user
up to 31 characters in length.
Pages printed
Total number of prints processed
through the image processor.
yes
0
Startup page
enabled
Indicates if the printer prints a startup
page upon power-up.
yes
No
Yes
Printer ID
The Ethernet address provided for
each printer.
yes
In the format
xx:xx:xx:xx:xx:xx
Adobe
PostScript
version
Tektronix version number of the
PostScript firmware running on the
printer’s processor.
yes
2015.105
Print engine FW
version number
Tektronix version number of the engine
firmware running on the printer’s
processor. Read from ROM and
stored in NVRAM.
yes
1.0/1.0
Any value
