Getting Started
5.
Edit the Diagnostic Log parameters that control which event messages will
be logged into the Aggregator.Log
fi
le. This
fi
le contains log messages at
the Aggregator level and is intended to be used as a diagnostic aid.
NOTE.
There is a separate DiagnosticLog setting in the Devices section of this
fi
le for limiting which event messages appear in the log
fi
les for a speci
fi
c
device.
a.
Change the DiagnosticLog Level parameter value to control which
events are logged into the Aggregator.Log
fi
le. The possible values
for this parameter are listed below. When this parameter is set to a
value other than Off, the selected message level and the levels that are
above the selected level will be logged. For example, if Info is set
as the logging level, all messages for Info and Error will be logged.
If Verbose is set as the logging level, all messages for Error, Info,
Debug, and Verbose will be logged. Entering the value Off turns off
the logging function. Entering the value All enables logging of all
messages.
Off
Error
Info
Debug
Verbose
All
b.
Change the DiagnosticLog MaxFileSizeInMB parameter value as
needed to increase or decrease the maximum
fi
le size in megabytes for
the Aggregator.Log
fi
le.
RFM220 User Manual
27
Summary of Contents for RFM220
