Getting Started
1–14
VX1411 MainFrame Instruction Manual
To mount with front and rear flanges inside of the rails, use mounting
method B shown in Figure 1–7 when doing step 8. This mounting method
assumes untapped holes.
8. Using the mounting method determined from the previous step, secure the
right slide-out track assembly to the front and rear rails. Seat the screws
fully, but lightly, to adjust the mounting later.
9. Tighten the screws left loose in step 4 to fix the front to rear flange spacing
of the slide-out track assembly.
10. Repeat steps 6 through 9 to mount the left slide-out track assembly.
Mounting method A
Mounting method B
Left-front rail
Left slide-out track
Left slide-out track
Use two flat head screws if the cabinet
rails have countersunk mounting holes;
otherwise use two pan head screws.
Use a bar nut if front
rails are not tapped.
10-32 Flat head
screw (4)
10-32 Pan head
screw (4)
10-32 Pan head screw
(4)
Left-front rail
Figure 1–7: Installing the slide-out track assemblies in the rack (top view)
WARNING.
Installing the VX1411 Mainframe in the rack requires at least two
people. Because of the size and weight of the mainframe, installing the main-
frame alone can result in personal injury or equipment damage. One person
should be on the left side of the mainframe with one hand holding the left front
handle and with the other hand underneath the mainframe. The other person
should do likewise on the right side of the mainframe.
11. Fully extend the inner tracks of each slide-out section out of the front of the
rack until they lock.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
