Maintenance
6–12
VX1411 MainFrame Instruction Manual
To remove the backplane, perform Procedures 1, 2, and 3. Refer to Figure 6–9
and then complete the following steps:
1. Remove the top cover of the mainframe (see Figure 6–8 on page 6–11, if
necessary).
2. Disconnect the power switch cable at J22 at the top of the backplane.
3. From the rear of the mainframe, remove the five 6-32 screws on the top of
the backplane, seven 6-32 screws from the center, and five 6-32 screws from
the bottom.
4. After removing all screws from the backplane, remove the backplane from
the mainframe by sliding it out of the right side.
Install the backplane by reversing the disassembly procedure.
Procedure 6: Remove the
Backplane
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com