www.tekvox.com
1201-N+
79033-N+ User Manual
5.6.4 Control TEK 1201-N+ from Local and Remote
This is the normal operation of the TEK 1201-N+ which also works with a TekMonitor at the HDBaseT
receiver.
1)
Connect the RS232 port of TEK 1201-N+ to RS232 port of PC.
2)
Send the command 50788% (serial control mode 1, factory default) via RS232 communication
software.
3)
Send any control command for the TEK 1201-N+ from either RS232 port on unit or HDBaseT
receiver. Connection is shown below:
Control 1201-N+ using TEKVOX Equipment