M I S C E L L A N E O U S C O N F I G U R A T I O N V I A T H E W E B
Rev H
118 of 244
Table 12-4 Advanced Calling Features Configuration Fields
Field Name
Description
Enable Call Waiting
Enables/disables Call Waiting feature. See
Call Waiting
on
Enable Caller ID display
Enables/disables the feature to view the CID of received
Calls.
Enable 3-way calling
Enables/disables Conference feature. See
Conference Call
on
Enable last call redial
Enables/disables Redialing Last Call feature.
See Redialing to
on page
Enable distinctive
ringtones
Enables/disables Distinctive Ring tones feature. See
on page
Enable call transfer
Enables/disables Blind Transfer Call (see
Blind Transfer Call
on page
). When a call is received, a Blind Transfer Call
can be done by dialing *98 (default key sequence) and then
the destination number. Once the transfer sequence is dialed
the call is immediately disconnected and the caller will
automatically try to create a new call with the destination
number.
Enable Do Not Disturb
(DND)
Enables/disables DND feature. See
Enable call forwarding
Enables/disables Call Forwarding feature. See
Forward a call
on page
on page
description.
Enable block/accept last
call
Enables/disables Block/Accept Last Call feature. See
on page
Enable auto redial
Enables/disables redialing a busy number. See
on page
Auto redial Expire Timer
value
The time period in seconds for dialing a busy number. The
default is 1800 seconds.
Enable Block Caller ID
Enables / Disables per-call to block sending Caller ID. See
for usage.
Enable Anonymous Call
Rejection (ACR)
Enables / Disables to reject calls from an anonymous source.
See
Anonymous Caller Rejection (ACR)
Show Caller identity on
Call Waiting
Enables seeing the name of the Caller on the call waiting.
4.
After making your selections, scroll down to the
Handset Advanced Configuration
portion of the page
which contains the Assigned Key Patterns settings
.
5.
The table below lists the available fields in this portion of the page.
6.
Complete your desired settings and click
Save Settings.
NOTE
After entering and saving all configurations, you MUST reset the Gateway.
See
Summary of Contents for AC - 232 - TX
