M I S C E L L A N E O U S C O N F I G U R A T I O N V I A T H E W E B
Rev H
126 of 244
Figure 12-11
Call Progress Tones Fields in the Ringing
Configuration Page
NOTE
After entering and saving all configurations, you MUST reset the Gateway.
Table 12-7 Call Progress Tones Descriptions
Field Name
Description and Default Configuration
Dial Tone
The FXS Dial Tone indicates that the network is ready to accept a
phone number.
Default:
350@-12+440@-12#ON(100),R
Busy Tone
This tone is played in the headset when the destination number is
engaged or when a call is ended.
Default:
480@-12+620@-12#ON(500),OFF(500),R
Reorder Tone
The Reorder Tone, also known as, Network Busy or Fast busy and
sounds like a fast busy signal, is played in the headset if a call can not be
completed due to a network error other than destination busy (line is
engaged).
Default:
480@-12+620@-12#ON(250),OFF(250),R
Off Hook Warning
Warning tones are heard when the receiver is left off hook. When
the receiver is picked up a dial tone is heard for the first 10 seconds.
After 10 seconds a Busy tone is heard for 20 seconds, and then
followed by a Receiver off-hook (ROH) warning tone for another 60
seconds. To change the periods or to disable the feature consult the
Auto Configuration manual. The default ROH tone used is:
1400@-6+2060@-6+2450@-6+2600@-6#[ON(100),OFF(100)]200
Summary of Contents for AC - 232 - TX
