M I S C E L L A N E O U S C O N F I G U R A T I O N V I A T H E W E B
Rev H
128 of 244
Examples
Example 1 - European dial tone
425@-5#ON(1000),R
The
tone is frequency 425Hz at level -5dbm and is repeated indefinitely.
Example 2
1800@100#[ON(500),OFF(100),ON(100)]4,ON(100),OFF(100),IDLE(2000),R
The Sequence ON-OFF-ON is repeated 4 times. After that, the Sequence ON(100),
OFF(100) and then Idle for two seconds is repeated indefinitely.
13.9
Fiber Optic Configuration
In VoIP Gateway units with the Fiber Optic Transceiver 100Base-FX option installed, port 8
can be configured to be a Fiber optic port or 100Base-TX. In units with 1000Base-LX or
1000Base-SX port option, port 9 is the Fiber Optic port and port 8 is always configured as
100Base-Tx.
NOTE
The capability to configure port 8 as FO or TX is not available on the GW-232
product. This feature is available only on the GW-282 product with 100Base-
FX uplink.
To select the configuration of port 8:
1.
In the vertical menu bar of the current VoIP Gateway Web page, select
Miscellaneous
.
2.
In the horizontal menu bar, select
FO
.
The
Fiber Optic Configuration Page
appears (
By default, port 8 is configured to be Fiber Optic.
3.
To use port 8 as a 100Base-TX port, select the
TX
option and click
Save Settings
.
Summary of Contents for AC - 232 - TX
