U P G R A D I N G T H E G A T E W A Y F I R M W A R E A N D D O W N L O A D I N G
C O N F I G U R A T I O N F I L E S
Rev H
62 of 244
If the Network configuration is not obtained dynamically, use the
set dhcp
(
se dh
) command in
Network Configuration mode.
IPG.Config.Network >
set dhcp y
2.
Use the
show autoconfig
(
sh a
) command in Network Configuration mode to verify that the
automatic configuration is enabled.
IPG.Config.Network >
show autoconfig
IPG.Config.Network >
IPG.Config.Network > autoconfig|a = y
If the automatic configuration is not enabled, use the
set autoconfig
(
se a
) command in
Network Configuration mode.
IPG.Config.Network >
set autoconfig y
3.
For Microsoft DHCP server:
•
Set the using of DHCP options 66, 67 by using the
set options6667
(
se o
) command in
Network Configuration mode. You can display the status of the DHCP options 66, 67
by using the
show options6667
(
sh o
) command in Network Configuration mode.
IPG.Config.Network >
set options6667 y
IPG.Config.Network >
show options6667
IPG.Config.Network >
IPG.Config.Network > options6667|o = y
•
Set the Automatic configuration ID to a value different from the value on the DHCP
server, by using the
set id
(
se id
) command in Network Configuration mode. You can
display the Automatic configuration ID by using the
show id
(
sh id
) command in
Network Configuration mode. To cause the configuration file to be executed on every
boot and half lease time without comparing to the ID stored in the Gateway, set the
DHCP server the ID to
always
.
IPG.Config.Network >
set id 5
IPG.Config.Network >
show id
IPG.Config.Network >
IPG.Config.Network > id|id = 5
•
Reboot the Gateway for applying the changes by using the
reboot power
(
r p
) command
in Commands mode.
IPG.Commands >
reboot power
IPG.Commands > Warning! Reset system (y/n) ?
y
8.5
Fixed (Provisioned) HTTP or TFTP Automatic
Configuration
You can supply the IP address of the HTTP/TFTP server and the name of the “root” configuration
file directly to the Gateway, instead of through the DHCP options. During boot, and at defined
Summary of Contents for AC - 232 - TX
