U P G R A D I N G T H E G A T E W A Y F I R M W A R E A N D D O W N L O A D I N G
C O N F I G U R A T I O N F I L E S
Rev H
64 of 244
IPG.Config.Network >
show autoconfig
IPG.Config.Network >
IPG.Config.Network > autoconfig|a = y
If automatic configuration disabled (n), enable it with the
set autoconfig
(
se a
) command in
Network Configuration mode.
IPG.Config.Network >
set autoconfig y
3.
Set the HTTP/TFTP server IP address for the location for the configuration files by
using the
set tftpip
(
se t
) command in Network Configuration mode. Use the
show
tftpip
(
sh t
) command in Network Configuration mode to verify the HTTP/TFTP
server IP address.
IPG.Config.Network >
set tftpip 10.2.197.9
IPG.Config.Network >
show tftpip
IPG.Config.Network >
IPG.Config.Network > tftpip|t = 10.2.197.9
4.
Set the “root” configuration file name by using the
set file
(
se f
) command in Network
Configuration mode. Use the
show file
(
sh f
) command in Network Configuration
mode to verify the name of the “root” configuration file.
The file name has the following syntax:
ipg_xxxx.cfg
where
xxxx
is free text.
IPG.Config.Network >
set file ipg_test.cfg
IPG.Config.Network >
show file
IPG.Config.Network >
IPG.Config.Network > file|f = ipg_test.cfg
5.
Reboot the Gateway to effect the changes by using the
reboot power
(
r p
) command
in Commands mode.
IPG.Commands >
reboot power
IPG.Commands > Warning! Reset system (y/n) ?
y
8.6
Creating and Encrypting Configuration Files
Use file
ipg_example.cfg
, as an example to create your own configuration file. Valid
commands can be found in the file
282_Autoconfig.pdf
. The “root” file name must be of
format
ipg_xxxx.cfg
. For added security, you can encrypt the “root” and General
configuration files.
To encrypt a configuration file:
1.
Install the encryption key(s) into the Gateway (see sections
Installing a General Configuration File Encryption Key
The maximum size is 64 characters.
2.
Encrypt the configuration file with the
gwBin
utility using the same encryption key that
you entered into the Gateway. Make sure that the name given to the encrypted file is of
format
ipg_xxxx.cfg
.
Summary of Contents for AC - 232 - TX
