U P G R A D I N G T H E G A T E W A Y F I R M W A R E A N D D O W N L O A D I N G
C O N F I G U R A T I O N F I L E S
Rev H
67 of 244
The IPG > prompt line indicates that the VoIP Gateway is in its main CLI mode. In this
mode, global and main-mode CLI commands are available.
To view the available commands in the current mode:
Press <?>.
A list of the available commands appears, describing each command briefly and showing
the minimal abbreviation allowed for each command name.
To apply a CLI command:
1. Type the command in lowercase characters. You may abbreviate any or all of the
keywords.
Examples of abbreviations: l or ? for list, en for end (as a rule, you may abbreviate
keywords down to the shortest unique abbreviation – any length between the full and
the shortest unique presentation is valid).
2. Press <Enter>.
To repeat a previously entered CLI command:
Repeatedly press on the UP ARROW key until the desired command appears. Up to 8 CLI
commands are kept in memory.
Summary of Contents for AC - 232 - TX
