C L I C O M M A N D M O D E S
Rev H
74 of 244
IPG >con
Table 9-4 Config Mode CLI Commands
Command
Description
Power
(not available for
232 products)
Accesses
power
settings.
In this mode the CLI commands show power parameters, set charger type (1 or 2),
perform battery test.
interface
Accesses
interface
mode.
In this mode the CLI commands enable or disable ports, configure their
duplex mode and speed, etc.
Note
: This configuration becomes active immediately. Reset is not required to
activate the change.
Temperature
(not available for
232 products)
Displays the temperature reading inside the unit (in C° and F°).
security
Accesses security mode.
Includes commands to set Advanced security.
The security and advanced security options, as accessed via the Web, are
described in Section
netconfig
Accesses
network
configuration mode.
In this mode the CLI commands enable setting DHCP or fixed IP mode, the
IP address of the VoIP Gateway, net mask, IP Gateway etc.
Once the Network parameters have been updated, reboot using the reboot
command or power up the unit.
If the DHCP option was selected you can view the IP address that was assigned to
the unit by the DHCP server. The current IP can also be viewed in the System
Information display invoked from the main mode by the CLI
show
command.
snmp
Accesses
snmp
mode.
This mode includes commands to set SNMP communities. You can find a
description of the SNMP options, as accessed via the Web, in section
10.7
.
vlan
Accesses
vlan
mode. VLAN configuration options, as accessed via the Web, are
described in
on page
http
Allows to enable/disable HTTP Web management (by default, HTTP Web
management is enabled).
h323
or
mgcp
or
sip
Accesses the selected VoIP protocol configuration mode.
The selected mode includes commands to set the H.323 or MGCP or SIP
configuration.
Mac
(not available for
232 products)
Accesses MAC mode to display (
show
command) MAC address table entry.
igmp
Provides commands used to configure
IGMP
, including set or show parameters,
and commands to
display
the following: IGMP General Query timers, IP Multicast
groups per VLAN, the IP Multicast VLANs per VLAN, Filtered IP Multicasts per
VLAN, all IGMP snooping status tables, statistics from IGMP snooping. Also
provides a command to
clear
IGMP snooping statistics.
Rstp
(not available for
232 products)
Includes commands to disable or enable
RSTP
.
Summary of Contents for AC - 232 - TX
