C O N F I G U R I N G T H E V O I P G A T E W A Y V I A T H E W E B
Rev H
92 of 244
3. You can use the
Del
key to remove a port, if it is not a member of the new VLAN.
4. Once the port members of a VLAN have been entered, you can assign the VLAN as the
default VLAN for one or more ports that belong to that VLAN. Select the proper VLAN
ID on the default
VLAN
row in all the required ports.
5. If you wish to remove a VLAN from the
VLAN
column, first make sure it is not a
default VLAN for any port. If it is, assign another VLAN as default for the port(s) and
then delete the original VLAN.
Once the VLAN configuration table is set and
VLAN Enable
is selected, packets received at
an VoIP Gateway port will be forwarded only to ports of the same VLAN (ports that have
their port member field set to “T” or “U” for that VLAN).
Traffic addressed to the VoIP Gateway unit (Web management or VoIP protocol frames) will
be received and transmitted on any of the defined VLANs.
Summary of Contents for AC - 232 - TX
