M I S C E L L A N E O U S C O N F I G U R A T I O N V I A T H E W E B
Rev H
125 of 244
Figure 12-10
Call Waiting Tone Cadence Fields in the Ringing
Configuration Page
The default Call Waiting tone is heard 5 times and has the Format:
440@-13#[on(300),IDLE(3700)]5
To change the tone to be heard 4 times use the format:
440@-13#[on(300),IDLE(3700)]4
For more details on Tone format, see the following section: Rings and Tones Detailed Format
Description
.
13.8.4 Call Progress Tones
Call Progress Tones are audible signals that are used to inform the caller or callee of the
progress of a call (e.g. ring tone, busy tone, etc.).
By default the
Call Progress Tones
parameters are null. The system uses the default Bellcore
definitions. The progress tones can be reconfigured in order to adapt to local country tones.
1.
Fill in the Call Progress Tones fields if you want to change their defaults (
).
The following tones are available:
Dial Tone, Busy Tone, Reorder Tone, Off Hook
Warning, Ringback Tone, Confirm Tone, Stutter Tone (MWI), Ring.
Refer to
Table 12-7 Call Progress Tones Descriptions
2.
Click
Save Call Progress Tones
.
Summary of Contents for AC - 232 - TX
