R S T P C O N F I G U R A T I O N V I A T E L N E T
Rev H
163 of 244
To enable the RSTP, type
rstp enable
:
IPG.Config.RSTP >
rstp enable
IPG.Config.RSTP >
YOU MUST NOW POWER CYCLE THE UNIT to complete rstp enabling as follows:
IPG.Config.RSTP >
end
IPG >
commands
IPG.Commands >
r p
IPG.Commands > Warning! Reset system (y/n) ?
y
IPG.Commands >Device rebooted to application via telnet.
YOUR TELNET CONNECTION WILL BE LOST. YOU MUST NOW LOGIN to the unit.
Then continue to configure RSTP as follows:
IPG >config
IPG.Config >rstp
IPG.Config.RSTP>
The following table summarizes the RSTP commands available in RSTP Configuration mode
after rstp is enabled and the unit is re-powered
.
.
Name
Value
Description
show
Displays the value of RSTP parameters.
rstp
{ enable/disable }
Enables/disables the RSTP option.
priority
<0-61440>
Sets the RSTP bridge priority.
hello-time
<1-9>
Sets the bridge hello-time in seconds.
forward-delay
<11-30>
Sets the bridge forward-delay in seconds.
max-age
<6-28>
Sets the bridge max-age time in seconds
force-version
<0|2>
Sets RSTP/STP compatibility.
interface
<1-10>
Sets RSTP port parameters.
help
Displays commands format.
list
Displays command list.
?
Same as the list command.
end
Exits current mode and goes to Main mode.
exit
Exits current mode and goes to previous mode.
quit
Quits the console.
18.2
RSTP Configuration Commands
18.2.1 enable/disable RSTP
The
rstp <enable|disable>
command enables/disables the Rapid-Spanning Tree option.
Summary of Contents for AC - 232 - TX
