O V E R V I E W
Rev H
18 of 244
VoIP Gateway
Descriptions of Port
Supported Protocols
options.
Uplink speed, fast or gigabit,
is determined by the speed of
the SFP.
This manual includes installation instructions for the indoor GW-232, GW-282 and AC-282,
VoIP Gateway products. For outdoor products - GW-282S/482S/483S/483D refer to the
following installation manuals for complete installation information for each of the other
product series:
GW-282S B-C Installation Guide (MN100113)
GW-282S A-D Installation Guide (MN100116)
A Method of Procedure (MOP) document, identified as MN-GW282S-MOP, is
available for performing component replacement in the 282S unit.
GW-482 VoIP Gateway Installation Guide (MN100143)
GW-483S VoIP Gateway Installation Guide (MN100167) – This model can be used
indoors and outdoors.
GW-483D VoIP Gateway Installation Guide – This model can be used indoors and
outdoors.
Where differences between this document and the Installation Guide exist, the Installation Guide
takes precedence.
NOTE
Because the user interfaces and operation of the products covered in this
manual are similar, the products will be referred to generically in this manual
as “the VoIP Gateway,” rather than by individual product name. Any
differences between products will be clearly noted.
This chapter includes an overview of these products and information for obtaining technical
assistance. The following chapters include brief installation instructions and full configuration
and software-upgrade instructions for using and managing the VoIP Gateway.
2.1
EdgeGate VoIP Gateway
232/282/282S/482S/483S/483D Product Overview
The EdgeGate VoIP Gateway 232/282/282S/482S/483S/483D is a terminal gateway device
with up to two Voice-over-IP (VoIP) ports on the 232, 483S and 483D models and up to four
VoIP ports on the 282/282S/482S models. Using these ports, independent analog telephone
lines or FAX machines are enabled to make VoIP phone calls over the Internet or Intranet. In
addition, up to nine work-stations or segments (for the most populated module in the series)
can be connected to the network. Local work-stations are connected via an Ethernet
10/100Base-TX interface. Uplink connections are provided through either a fiber optics cable
(EdgeGate products) or a copper cable (Access products).
Summary of Contents for AC - 232 - TX
