I N T E R F A C E C O N F I G U R A T I O N V I A T E L N E T
Rev H
200 of 244
fulll000
Sets the interface’s duplex speed mode to full duplex 1000M.
24.2.4 Enabling Flow Control on the Interface
The
set flowcontrol
command, in Interface Configuration mode, enables flow control on the
interface. The
no
form of the command restores the flow control status to its default.
By default, the flow control on all interfaces is disabled (off).
Command Syntax
IPG.Config.Interface >
set
<
port
>
flowcontrol
{
on
|
off
}
IPG.Config.Interface >
no set
<
port
>
flowcontrol
IPG.Config.Interface >
se
<
port
>
f
{
on
|
of
}
IPG.Config.Interface >
no se
<
port
>
f
Argument Description
port
Interface number in the range <1-4>
on
Enables flow control.
off
Disables flow control.
24.3
Interface Displaying Commands
lists the Interface displaying commands.
Table 23-3 Interface Displaying Commands
Command
Description
show
Displays the specified interface configuration.
show all
Displays the configuration of all the interfaces.
24.3.1 Displaying the Specified Interface Configuration
The
show
command, in Interface Configuration mode, displays the specified interface
configuration.
Command Syntax
IPG.Config.Interface >
show
<
port
>
IPG.Config.Interface >
sh
<
port
>
Argument Description
port
Interface number in the range <1-4>
Example
IPG.Config.Interface >
show
1
Summary of Contents for AC - 232 - TX
