P R O T O C O L H . 3 2 3 C O N F I G U R A T I O N V I A T E L N E T
Rev H
238 of 244
Set the “Name” you want to show on the called party’s Caller ID display. When you make a call
from a line of the Gateway with the Caller ID inserted, the remote called party will receive this
string.
By default, the Gateway US version is factory set to FSK (Bellcore) CID.
Command Syntax
IPG.Config.H323 >
set 2cidname
STRING
IPG.Config.H323 >
no set 2cidname
IPG.Config.H323 >
se
2c
STRING
IPG.Config.H323 >
no se 2c
Argument Description
STRING
Caller ID for line 2.
28.3
H.323 Displaying Commands
lists the H.323 displaying commands.
Table 27-3 H.323 Displaying Commands
Command
Description
show all
Displays the entire H.323 configuration.
show gatekeeperip
Displays the gatekeeper IP address.
show dialplan
Displays the dial plan matching string.
show 1number
Displays the phone number of line 1.
show 2number
Displays the phone number of line 2.
show 1cidname
Displays the caller ID for line 1.
show 2cidname
Displays the caller ID for line 2.
28.3.1 Displaying All H.323 Configuration Parameters
The
show all
command, in H.323 Configuration mode, displays all H.323 configuration
parameters.
Command Syntax
IPG.Config.H323 >
show all
IPG.Config.H323 >
sh all
Summary of Contents for AC - 232 - TX
