I N S T A L L A T I O N
Rev H
27 of 244
4
Installation
The Installation chapter provides installation instructions for the indoor EdgeGate units only.
These include: GW-232, GW-282 or AC-282.
For the outdoor EdgeGate units, refer to the relevant unit's Installation Guide.
The GW-282 and AC-282 must be powered by an external UL listed limited
power source or Class II power source (AC/DC adapter), rated input: 100-
250 V, 47-63Hz, 0.2A, output as specified under the power connector on the
device. The GW-232 and AC-232 must be powered by an external UL listed
limited power source or Class II power source (AC/DC adapter), rated input:
100-240 VAC@0.5A, 47-63Hz, 5V@2.4A output.
For outdoor products GW-282S, GW-482S, GW-483S and GW-483D, refer to
the relevant installation guide for power specifications and installation
information.
ONLY the PSTN (Life Line) port can be connected to the Public
Telecommunication Network. The Phone ports are intended for indoor
connections only and may not be connected to the Telecommunication
Network.
4.1
Installing the EdgeGate
To install your indoor VoIP Gateway unit:
1. Unpack the EdgeGate unit.
shows the connectors on the rear of the AC-282 (copper port) and GW-282
(fiber optic port).
•
The AC-282 provides a copper cable connector. The GW-232 and GW-282 provide
a fiber optic connector.
•
The RJ-11 telephone ports Phone 1, Phone 2, Phone 3, and Phone 4 connect to the
telephony devices.
•
The PSTN (lifeline) port can be connected as a standby to the public telephone
network. In case of power failure, the phone connected to the Phone 1 port will be
automatically switched from VoIP to this line, for regular telephone communication.
•
The LAN 10/100BaseTX and any of the available fiber optic ports connect to the
LAN, to other VoIP Gateway units and to computers.
•
The AUX/Console port (not available on all AC-232 products) connects to the serial
port on a PC for configuring the unit.
Console Grounding:
The RS-232 cable must be connected to a floating PC
(i.e., laptop) to prevent the unit from being permanently damaged. Telco
Systems offers a console cable for use by service personnel configuring this
product.
Summary of Contents for AC - 232 - TX
