I N I T I A L C O N F I G U R A T I O N A N D B A C K G R O U N D I N F O R M A T I O N
Rev H
43 of 244
6.1
Keypad Configuration (Enabled only on 232 Gateway
products)
Basic configuration commands such as setting factory defaults and changing the IP mode from
DHCP to fixed, or hearing the current IP address announced, can be done by entering
configuration commands using the telephone keypad. Use this option if you have lost normal
access to the Gateway via a PC. The following commands are active ten minutes from boot on
the telephone connected to line 1.
To set the factory defaults:
Dial ##3332858 (D,E,F,A,U,L,T). Once the command is accepted, the Management LED on
the front panel will glow a steady green and after about 30 seconds the unit will power up with
factory defaults.
To set the IP mode:
To change the IP mode from DHCP to fixed or vice-versa, dial ##3427937 (D,H,C,P,Y,E,S)
for DHCP or ##342766 (D,H,C,P,N,O) for fixed IP 10.1.0.54 Mask 255.255.0.0. The
Management LED on the front panel will glow a steady green for about 3 seconds and the unit
will boot with the required IP setting.
To hear the current IP address announced over the headset:
Dial ## 472337 (I,P,A,D,D,R).
6.1.1
Keypad Configuration for MGCP
If the Keypad Configuration option is used before the Gateway is registered with the Call
Agent, dial tone and other tones like “busy” will not be generated. To use the Keypad
Configuration option, dial a valid Keypad Configuration sequence. If the “dot” confirmation is
not heard after a short period, put the handset on the hook and repeat the dialed sequence.
Summary of Contents for AC - 232 - TX
