39
Installing the Equipment
2.5.7
Start Up
After powering up the 3200 series 1+1 system, you must configure both units, one as primary and the
other as secondary.
Once these configuration settings are applied, your 3200 series 1+1 system will start up and display the
web portal configuration management tool.
Note
To learn about the IP address for your system or how to change it, refer to
“Changing the 3200 Series Gateway Management Port IP Address” on page
55.
1.
Connect to the web portal (http://[MGMT0 IP address]:12358) and select the role of the unit to be
part of a 1+1 redundant system.
Note:
The Welcome page indicates whether the 3200 series unit is primary or secondary.
2.
Follow the instructions of the web portal to configure the units of your 3200 series 1+1 system.
Indicate the following:
• Select Primary for the 3200 Series and Secondary for the 3200 1.
• VLAN IDs: By default the system will be using VLAN IDs 710 and 711 between the two units. You
may need to change this if it conflicts with your network.