3200 Series Standalone and 3200 Series 1+1 System Installation Guide
50
2.8
Powering Down
Attention
DO NOT TURN OFF the power to the 3200 series gateway using the power switch
located at the rear, unless the Linux host has been properly shut down beforehand. Use
the reset button display, or manually use the shutdown command.
Allow enough time for the Linux host to shut down before turning off the power to the
3200 series system (example. 1 minute). Be aware that the shutdown procedure of the
unit is logged and traceable for support and warranty purposes.
2.8.1
Local Method
To power down the 3200 series, press and hold the reset button for two seconds.
2.8.2
Remote Method
To power down, you must connect to the management interface using SSH, and enter:
shutdown -hP now
Reset B
u
tton
