53
Initial System Configuration
3.2.1.1
Connecting to the USB Port of the 3200 Series Gateway
The Type B USB serial port interface enables administrators to perform management tasks on the 3200
series gateway.
Note
The USB cable is not provided.
To connect to the Type B USB serial port of an 3200 series gateway:
1.
Connect the Type A USB connector of the USB cable to a computer.
2.
Connect the Type B USB connector of the USB cable to the USB port of the 3200 Series gateway.
Figure
3.2
USB cable connection
3.2.1.2
Connecting to the Serial Port of the 3200 Series Gateway
Note
The default IP addresses for the management ports are located in the “Important Notice”
sheet received with the shipment.
If you do not know the default IP address, go to
Gateway Management Port IP Address” on page
The serial port interface enables administrators to perform management tasks on the 3200 series
gateway.
To connect to the serial port of a 3200 series gateway:
1.
Connect one end of a CAT5 RJ-45 (male-male) cable to the Tmedia serial adapter (both supplied
with unit). Connect the DB9 to RJ-45 to the serial port of the computer and the other end of the
CAT5 RJ-45 (male-male) cable to the serial port (labeled 10101) of the 3200 series gateway. See
Section
61 for a RJ-45 pin-out description.
To
C
omp
u
ter
