TMG7800 Series System Installation Guide
62
Method 3: VGA Monitor, USB Keyboard, and USB Mouse
1.
Connect a VGA monitor to the VGA port of the 7800-CTRL. Connect a USB keyboard to an
available USB port on the 7800-CTRL. Do the same for a USB mouse See
figure
9.4 on page
62.
Figure
9.4
USB to DB9 Adapter
9.2.2
Configuring the Terminal Emulator Application
Before initiating communication with the management interface, you must first configure a terminal
emulator or console application to communicate with the 7800 series system in order to configure initial
settings. Available terminal emulation software includes:
•
SecureCRT
•
Putty
•
Minicom
To configure the terminal emulator application:
1.
Set the baud rate (bits per second) to
9600
2.
Set the data rate to
8 bits
3.
Set the parity to
None
4.
Set the stop bits to
1
5.
Set the flow control to
None
Note
See
Section
9.3 on page
62 to learn how to change the IP address of the MGMT0 port.
9.3
Changing the 7800 Series Gateway Management Port IP
Address
The management port of the 7800 series gateway (MGMT0 and MGMT1) are configured in bonding by
default and the values are located on the “Important Notice” sheet.
VGA Monitor
