DESCRIPTION OF PARTS
Fig.1 - transmitter box
1
Box
2
Fixing brackets
3
Seal
4
Cover
Fig. 4 - Transmitter
1
Pt1 button
2
Setting dip-switches
3
Indicator LED
4
Terminal board for sensitive edge input
Fig. 7 - Receiver
1
Setting dip-switches
2
Indicator LED
3
Pr1 memorisation button
4
TEST input terminal board
5
Power supply and SENSITIVE EDGE signal output terminal
board
6
COSTA 2 (SENSITIVE EDGE 2) setting jumper
7
COSTA 1 (SENSITIVE EDGE 1) setting jumper
8
12/24 V power supply selection jumper
INSTALLING TRANSMITTER
1) Mount the transmitter
in the highest point of the gate
with the
aerial pointing downwards and near the sensitive edge (Fig. 3).
2) Connect the sensitive edge to the clamp of the transmitter, with
a cable
max 5 meters long and section minimum 1mmq
(4 in
Fig. 4).
The sensitive edge must be of the 8.2 kOhm balanced NO
type. If you use a NC sensitive edge you must use the
resistence 8,2 KOhm in series. Run the cables as closely as
possible to the terminal board (Fig. 2).
GB
30
