elmeg DECT200 Multicell System / en / elmegDECT200M_en / appendix.fm / 18.10.2013
V
e
rsion 1, 01.0
7
.2012
105
elmeg DECT200 Multicell System
bintec elmeg
Appendix
Appendix
Care
Wipe the base station, charging cradle and handset with a
damp
cloth (do not use solvent) or
an antistatic cloth.
Never
use a dry cloth. This can cause static.
Impairments in high-gloss finishes can be carefully removed using display polishes for mobile
phones.
Contact with liquid
If the device has come into contact with liquid:
§§1§§
Disconnect the power adapter
.
§§2§§
Allow the liquid to drain from the device.
§§3§§
Pat all parts dry. Then leave the device in a warm, dry location for
at least 72 hours
(
not
in a
microwave, oven or similar).
§§4§§
Do not switch on the device again until it is completely dry.
When it has fully dried out, you will usually be able to use it again.
In rare cases, contact with chemical substances can cause changes to the telephone's exterior.
Due to the wide variety of chemical products available on the market, it was not possible to test
all substances.
Specifications
Power consumption
elmeg DECT200M
(DECT Manager)
2.3 W
elmeg DECT200
(Base station)
Standby:
3.0 W
Call:
3.1 W
for one DECT connection
3.3 W
for 8 DECT connections (narrowband)
!
Summary of Contents for BinTec Elmeg DECT200
Page 3: ......
