GetMagic
7
type all Node IDs separated by comma. To control multichannel association of the device go to advanced view of
the device. Click on Node ID field of the device and in the field enter Node ID/Endpoint of the device to associate.
For example 26/2 where 26 is a Node Id and 2 is Endpoint.
To remove/replace failed node click on home setup, select a gateway and click on Add device. Click and hold the
failed device. A popup will appear with remove and replace options. To reset Z-Wave to default settings perform
factory reset of the Gateway.
The instructions for the inclusion/exclusion of Z-Wave sensors are given in their respective instruction manuals.
It is advisable to consult these instructions before proceeding with the process.
4.6 ZigBee node management
The process for adding Zigbee devices to the network is similar to the one used for Z-Wave devices but the
button used is the Button 1, instead.
4.7 Reset procedures
Gateway reset
The gateway reset is done by holding down button from 1 to 5 seconds. During this period LED will blink at 1
second rate.
Network reset
Resetting network configuration is done by holding down the button from 5 to 15 seconds. During this period
LED will blink with rate 1/4 second, then the gateway will reboot; if the LAN cable is wired, the Ethernet
connectivity will be enabled, otherwise the gateway will turn to the Access Point mode (Chapter 4.1 ).
Factory Reset
It is operated by holding down button from 15 to 30 seconds. When factory reset operation is selected, the LED
will blink and rate 1/10 second. If button remains pressed for more than 30 seconds, nothing happens.
5 GetMagic Application Manual
5.1 Account management
5.1.1 Creating new account
1.
Press “
Create new account” button on Login screen (see Fig 3).
2.
Fill in account name and password on Sign up screen. Account name must be a valid email address. It will be
used to send account activation mail.
3.
Agree with terms of services and press . Complete term of services text can be read by pressing “
Terms of
services” button.
4.
Fill in account details and press. All the fields marked with (*) are optional and can be updated later.
5.
Fill in personal information and press next button to complete wizard.
6.
If account is registered success message is presented and activation mail is sent to mail specified by account
name (make sure that the email is not stored in the Spam folder). Otherwise error message will be presented.
7.
Confirm activation link that is provided in activation mail.
