English
TS6281
5
3 First time installation
When all the connections on the receiver are ready (section 2.2) and the main lead is plugged in, the
receiver will start up automatically. If this does not happen, press the ON button on the remote control.
An easy installation menu will be displayed where you can set different parameters and then run the channel
scan:
OSD Language
Use the arrow / button to select a language for the On Screen Display menu (OSD). Press to go to
the next parameter.
Region
Use the arrow / buttons to select your Country. Press to proceed.
CAUTION
If the wrong country is selected the channel scan may not detect all the channels available.
LCN Mode
When the Logical Channel Numbering option is active, after the scanning, the TV/Radio services will be
automatically stored in the list following the order requested by broadcasters. Press
to go forward.
NOTE
When
LCN Mode
is turned on, we suggest to not change the channel positions in the
TV/Radio Channel List
menu.
Tuner Setting
(Antenna Power)
If you are using an active antenna press / to power the antenna, this is necessary when, for instance, an
indoor amplified antenna that is powered by the receiver.
CAUTION
With a traditional antenna, like typical rooftop models, or an independently powered antenna, the antenna power option
must be set to off: risk of overload!
Channel Scan
Press OK item to start the automatic channel scan. When the scan is completed, if there are no LCN conflict,
the receiver will enter the viewing mode.
LCN Conflict Resolution
When the LCN function is active (see above) and more than a service asks for the same channel list
position, the system will recognize that conflict and display on screen a list of the involved services. Choose
the preferred channel using / arrow buttons e confirm with OK. As an alternative, go to the automatic
solution. Also, if the user doesn’t make a choice, after a few, the appliance will carry out a solution by itself.
After these actions, the receiver will enter the viewing mode.
Clock Regulation
Enter the
Setup
-
Region and Time
menu to adjust the receiver clock. In particular, verify the
Summer
Time
option (par. 4.5). Use / arrow buttons and quit the menu with EXIT.
Video Configuration
For TV SCART output settings, go to
Setup
-
TV System
menu and regulate
Aspect Ratio
(
16:9 Full
Screen
/
Pillar Box
or
4:3 Letter Box
/
Pan Scan
) and
Video Output
(
RGB
or
CVBS
) respecting the technical
characteristics of the connected screen.
