TeleAdapt MediaHub Mini
|
Installation Guide
11
Step 6 (applies only if serial control is used)
If using serial control then connect the RJ45 end of the serial cable
to the RJ45 socket on the rear of the MediaHub Mini.
Step 7
Ensure that the PSU is NOT plugged into the mains. Next plug the
right-angled DC connector from the PSU into the matching connector
on the rear of the MediaHub Mini. Route the DC cable towards the
HDMI cable and secure it using the supplied cable tie to the same
loop the HDMI cable is attached to.
Step 8
Carefully rotate the MediaHub Mini into the prepared cutout ensuring
that the rear cables are not snagged, pinched or deformed. Fix the
MediaHub Mini to the furniture using either the wood screws or the
bolts, washers and nuts provided. Take care that the screws or bolts
do not damage the cables. Ensure the MediaHub Mini is straight and
flush fitting.
Step 9
Snap on the desired trim (Black or Metallic) ensuring the cutouts to
allow the trim to be released are on the bottom.
Step 10
Mains power can now be applied to the PSU. The Bluetooth button
on the front of the MediaHub Mini should light for about a second
shortly after power is applied.
