Model 458-3SL (3-Slot Chassis) Rev A
Page 23
4. Note the default COM port selected. This is the COM port used with the terminal emulation
program. Click
OK
to return to the Redirector configuration window.
5. Click
Add IP
on the right side of the screen. The IP Service Setup screen is shown.
6. Enter the IP address assigned to the XPort in the
Host
field. Enter
10001
in the
TCPPort
field.
Click
OK
to return to the Redirector configuration screen.
7. Click Port Settings in the center of the screen. The Port Settings screen is displayed.
8. Select
Raw Mode
and click
OK
to return to the Redirector configuration window.
9. Click
Save
. The message “
Changes will take affect when port is reopened
” is shown. Click
OK
to exit the program.
