Configuration without Kit
By this configuration, the remote control only controls your Black Box. The TV and DECODER are not
part of a Kit, they will therefore be controlled via the remote controls supplied by the related manufacturers.
Connection diagram
a) Connect the grey cable (motors) to the MOTOR UNIT connector and the white coax cable
(antenna) to the LNB connector of the Black Box.
b) Connect the BLACK cable of the Black Box to the NEGATIVE POLE of the vehicle 12 Volt Battery
and the RED cable to the POSITIVE POLE + (remember not to mix the + and - poles up), using
2 cables of 2.5 mm2 cross section.
c) The GREEN safety cable of the Black Box must be connected to Pin 15 of the vehicle ignition key
cylinder (D+). In this way, whenever the engine is started, this cable receives a po12 Vdc
voltage, which will automatically lower the antenna and lock all functions of the Black Box.
19)
Connecting the Decoder
a) Connect the RECEIVER connector of the Black Box to the LNB input of the Decoder via a coax
cable.
b) Connect the RECEIVER IN connector of the Black Box to the Scart output of the Decoder via a
Scart cable.
20)
Connecting the TV
a) Connect the TV SCART connector of the Black Box to the Scart input of the TV via a Scart cable.
21
MIR
TV
Not
Supplied
DECODER
Not Supplied
WARNING
Any power connection made in points other
than as indicated (e.g. on the alternator) can
give rise to equipment malfunction and/or
damage resulting in loss of the warranty.
White
Green
Grey
Not
connected
red
black
Not
connected
Summary of Contents for FlatSat Elegance
