GB
3
Installation
Before beginning the installation operations, cover the solar panel surface with a
cardboard sheet (you can use the packaging) and secure it with adhesive tape.
If the solar panel is damaged during installation, it can no longer be repaired.
Fix the 4 support feet (
5
) to the solar panel with the supplied screws, and tighten to a
torque of 2.5 Nm (see
Fig.3
).
FIG. 3
Connect the extension cable (
9
) by inserting the special pins MC3. The connection point
between the solar panel and the PV cable should be under the solar panel frame, to
ensure that the connector is protected from water.
Mark the glueing areas for the feet on the roof, and before glueing on the panel,
thoroughly clean those areas and the bottom of all 4 feet with the supplied Quick
Cleaner.
Surface protection treatments and carwash waxing will decrease the glue adhesion
power on the roof.
If necessary, before cleaning with the cleaner, polish the surfaces with 100 – 120 grit
sandpaper. To introduce the TEROSON MS930 tube in the special applicator, the cap
should be removed with a special tool.
Summary of Contents for TSP 130W
