20
www.behnke-online.com
GB
Introduction
GB
IP camera Instructions
1.
introduction
1.1. What’s in the box
▸
IP camera module 20-2940-IP/21-2940-IP/
50-2940-IP is only suitable for mounting
in vertical Behnke frames, and cannot be
installed in the lowest module (
❎
) mount-
ing position of a Behnke frame. The camera
board prevents the mounting of the module
housing.
▸
IP camera module 20-2941-IP/21-2941-IP
is only suitable for installation in horizontal
Behnke frames, and cannot be installed in the
outermost module (
❎
) mounting position of a
Behnke frame. The camera board prevents the
mounting of the module housing.
▸
IP camera module 43-2940
▸
Patch cable directly connected to the camera
▸
Password to access the camera (to be found
on the camera cover and in the present
manual)
▸
The present instructions
Caution:
IP camera may only be operated with
cover. Operation without the camera cover will
damage the camera. When opening the camera
cover for service purposes, only loosen the two
outer screws and carefully lift off the camera
cover. Heat sink in cover connected to camera.
Be careful not to scratch, damage or leave fin-
gerprints on the dome cover because this could
decrease image quality. If possible, keep the
protective plastic on the dome cover until the
installation is complete.
✅
✅
✅
✅
❎
❎
*
*
*
example for 20-0001/20-0001A-IP (3 Case elektronic). Available with 20-0014/20-0014A-IP (electronic
2 case), 20-0043-20-0043A-IP (electronic 4 case)
