13
*Only available under “continuous transmitting” mode.
LED ON/OFF
“LED-OFF”:
LED indicator will remain OFF during normal operation to save battery
power but it is still available for warning and fault indication.
“LED-ON”:
LED indicator will be lighten with green color when
transmitting.
LED OFF-Time
This setting allows you to select the LED intermittent time to save transmitter
power. i.e.: If select 1 second is selected, the LED will be lighted every 1
second.
Passive Act
This function ensures safe operations, including when there are disturbances
that may affect the normal operating conditions. This assures that when the
machine operates, the control is not subject to temporary and unexpected
stops. Possible short interferences are bypassed. The passive act can be select
in 2 mode as below,
“Ry Off”
If the interferences are larger than the pre-set
time, the receiver will turn off all the relays under “NORMAL” function
except the MAIN relay.
“Power-Off”
If the interferences are larger than the default time setting, the
receiver will turn off all the relays under “NORMAL” function setting and
“Control by EMS” including MAIN relay. The receiver must be restart to
operate again, follow the “Power-On” procedure to restart the system.
AUTO OFF RX
This function refers to turn off receiver after a given idle time. Receiver
MAIN relay will be turn off automatically. Normally this function is
cooperated with “non-continuous transmitting” mode to prevent any
unintentional radio.
