9
4–3 General Operation
1. Install four AA size batteries in the transmitter and make sure the "+" and "-"
direction are correct.
2. Insert the rotary key into the keyhole at "OFF" position and then turn
clockwise to "ON" position.
3. Press the "Start" pushbutton to Power-On.
Note:
If fail to follow the procedure above, the LED light will indicate fast flashing
in red.
4. Operate normally according to the function setting has done.
5. Please proceed the following procedure after operation.
a) Press EMS mushroom
b) Turn the rotary key to "OFF" position.
c) Remove the rotary key.
d) Remove the batteries when the equipment is not going to be used for a
long period of time
Note:
1. There is a 3-stage power indicating function with LED display.
(1) "Green color": Sufficient power to operate transmitter.
(2) "Yellow color": Power is depleting. Operation must be stopped
immediately (for example: down the loads to ground) to replace batteries.
(3) "Red color": Insufficient power. Transmitter will send out an emergency
stop signal to the receiver due to insufficient power. Operator should avoid
this situation in order to maintain the safety of operation.
2. Turn the rotary key of the transmitter to "OFF" position; it will not only shut
off the motion of the receiver but also save the power. Otherwise, the
transmitter will keep staying in the standby mode and causing more power
consumption.
Summary of Contents for F25
Page 1: ......
Page 2: ......
Page 11: ...8 4 2 F25 Receiver s parts Antenna Wiring Diagram Power On Indicator ...
