HDS2800 Operation and Installation
TeleDelta is proudly an Australian owned company.
File: hds2800 rev 4
www.teledelta.com
Page 8 of 18
4.2 Input configuration setting
4.2.1 Select the Input(n) setting.
A HDMI input card is shown below
Label
Options
Comment
Video format
User set
MPEG2 / H.264 selectable video format on certain HD (HDMI) frames
Video bit rate
User set
The range is 1~19.5Mbps*
Audio format / bit rate:,
Default
The default value is MPEG2 and 128kbps and is not normally changed
Program out enabled
User set
Turn on/off program output
Program name
User set
Enter the program name to be displayed on the TV
PMT/Video/Audio/PCR
PID.
Default
System will automatically select the default values
Encoding and video
indicators
Indication only
Green is normal, Red is fault
HDMI input: it
Indication only
Indicates if there is real-time HDMI signal present
Video format:
Indication only
the current video format of the device
Bit rate:
Indication only
the current encoding bit rate
Interface settings must be altered to reflect the input modules on the HDS-2800.
For RCA modules the interface defaults to VGA, this must be changed to RCA.
The aspect ratio for RCA input modules must also be changed to 16:9.
Repeat the setup as required for all inputs fitted (1-4).
