Teledex BTX4510, User Manual

The BTX4510 telephone can be wall mounted. It is easiest
to do the conversion when the handset and line cords are
not connected.

1. Located on the front of the telephone above the speaker
grill is the wall/desk mount clip. Remove this clip by firmly
pushing upward (toward the hookswitch).

2. Rotate the clip a half turn (180 degrees) so that the side
with the protruding edge is towards the top.
This edge will hold the handset.

3. Slide the clip downward into the same slot until it stops
(snaps into place).

4. Turn the BTX4510 over (place on a non abrasive
surface) so the back side is up, facing you.

5. Locate the mounting bracket, and firmly push back and
pull up to remove. NOTE: There are (4) retaining tabs.

6. Rotate the mounting bracket a half turn (180 degrees)
so that the mounting eyelet is facing in the same direction
as the mounting eyelet located on the bottom surface of
the telephone.

7. Insert the top two retaining tabs of the mounting brack-
ets into the mounting bracket slots located near the
middle of the telephone, then firmly push down and
insert the retaining tabs on the opposite side.

8. Connect a short modular line cord into the jack on the
back of the phone (labeled TO TEL.). Route the line cord
through the line cord channel. Connect the other end of
line cord to the phone jack on the wall mounting plate.

9. Turn the telephone over, and slide the BTX4510 onto the
mounting posts on the wall plate in a downward direction.
Both eyelets should  line up with the mounting posts.
(When properly installed the telephone will be stable and
secure.)

10. Complete the wall mounting by installing the handset
and handset cord.

CONVERTING FROM DESK TO WALL MOUNT

Back View– mounting bracket is shown
 in the Desk Mount Configuration

Removable
mounting bracket,
turned 180
degrees (for wall
mount  installation)

Back View—Mounting bracket shown
is in the Wall Mount Configuration