CARE AND MAINTENANCE
Your Pearl S telephone has been designed to provide years of trouble
free service. To ensure its longevity, please follow these maintenance
instructions:
1) Keep the Pearl S away from heat, as high temperatures can shorten
the life of the electrical components, and distort or melt plastic
parts.
2) The telephone should be kept free of dust and moisture. If it
gets wet, wipe it dry immediately. Liquids may contain minerals
that can corrode electronic circuits.
3) Handle your telephone gently and carefully. Dropping it can
cause serious damage to internal circuitry or the plastic case,
which may result in malfunction.
4) Do not use any type of chemical or abrasive powder to clean the
outer casing. Use only mild detergents on a soft, damp cloth to
clean the telephone.
5) In case of trouble with the telephone, do not attempt to repair
the telephone yourself. Contact your distributor for assistance.
If the trouble is affecting the telephone lines, the phone company
or service provider may ask you to disconnect the telephone
until the problem is resolved.
APPROVALS
The Pearl S telephone has been approved to the following standards:
• iCTR37 and TBR38
• EN 60950: 2000
• EN 55022: 1998 Class B
• EN61000-4-2 1995 as required by EN 55024: 1998
• EN61000-4-3 1996 as required by EN 55024: 1998
• EN61000-4-4 1995 as required by EN 55024: 1998
• EN61000-4-5 1995 as required by EN 55024: 1998
• EN61000-4-6 1996 as required by EN 55024: 1998
• EN61000-4-8 1995 as required by EN 55024: 1998
IMPORTANT SAFETY INSTRUCTIONS
WHEN USING YOUR TELEPHONE EQUIPMENT, BASIC SAFETY PRECAUTIONS SHOULD
ALWAYS BE FOLLOWED TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK AND INJURY
TO PERSONS, INCLUDING THE FOLLOWING:
1. READ AND UNDERSTAND ALL INSTRUCTIONS.
2. FOLLOW ALL WARNINGS AND INSTRUCTIONS MARKED ON THE PRODUCT.
3. UNPLUG THE PRODUCT FROM THE WALL OUTLET BEFORE CLEANING. DO NOT USE
LIQUID CLEANER OR AEROSOL CLEANERS. USE A DAMP CLOTH FOR CLEANING.
4. DO NOT USE THIS PRODUCT NEAR WATER, FOR EXAMPLE: NEAR A BATHTUB, WASH
BOWL, KITCHEN SINK OR LAUNDRY TUB, IN A WET BASEMENT, OR NEAR A SWIMMING POOL.
5. DO NOT PLACE THIS PRODUCT ON AN UNSTABLE CART, STAND OR TABLE. THE PROD-
UCT MAY FALL, CAUSING SERIOUS DAMAGE TO THE PRODUCT.
6. SLOTS AND OPENINGS IN THE CABINET AND THE BACK OF BOTTOM ARE PROVIDED
FOR VENTILATION. THESE OPENINGS MUST NOT BE BLOCKED OR COVERED. THE
OPENINGS SHOULD NEVER BE BLOCKED BY PLACING THE PRODUCT ON A BED, SOFA,
RUG OR ANY OTHER SIMILAR SURFACE. THIS PRODUCT SHOULD NEVER BE PLACED
NEAR OR OVER A RADIATOR OR HEAT REGISTER. THIS PRODUCT SHOULD NOT BE
PLACED IN A BUILT-IN INSTALLATION UNLESS PROPER VENTILATION IS PROVIDED.
7. NEVER PUSH OBJECTS OF ANY KIND INTO THIS PRODUCT THROUGH CABINET SLOTS
AS THEY MAY TOUCH DANGEROUS VOLTAGE POINTS OR CAUSE A SHORT CIRCUIT THAT
COULD RESULT IN A FIRE OR ELECTRIC SHOCK. NEVER SPILL LIQUID OF ANY KIND ON
THE PRODUCT.
8. TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT DISASSEMBLE THIS PRODUCT.
IF SERVICE IS NECESSARY, SEND OR TAKE THE TELEPHONE TO A QUALIFIED SERVICE
FACILITY. OPENING OR REMOVING COVERS MAY EXPOSE YOU TO DANGEROUS VOLT-
AGES OR OTHER RISKS. INCORRECT REASSEMBLY CAN CAUSE ELECTRIC SHOCK
WHEN THE APPLIANCE IS SUBSEQUENTLY USED.
9. UNPLUG THIS PRODUCT FROM THE WALL OUTLET AND REFER SERVICING TO QUALI-
FIED SERVICE PERSONNEL UNDER THE FOLLOWING CONDITIONS:
•
IF THE POWER SUPPLY CORD OR PLUG IS DAMAGED OR FRAYED
•
ID LIQUID HAS BEEN SPILLED INTO THE PRODUCT
•
IF THE PRODUCT HAS BEEN EXPOSED TO RAIN OR WATER
•
IF THE PRODUCT DOES NOT OPERATE NORMALLY BY FOLLOWING THE
OPERATING INSTRUCTIONS. ADJUST ONLY THOSE CONTROLS THAT ARE
COVERED BY THE OPERATING INSTRUCTIONS, AS IMPROPER ADJUSTMENT OF
OTHER CONTROLS MAY RESULT IN DAMAGE AND WILL OFTEN REQUIRE
EXTENSIVE WORK BY A QUALIFED TECHNICIAN TO RESTORE THE PRODUCT TO
NORMAL OPERATION.
•
IF THE PRODUCT HAS BEEN DROPPED OR THE CABINET HAS BEEN DAMAGED.
•
IF THE PRODUCT EXHIBITS A DISTINCT CHANGE IN PERFORMANCE.
10. AVOID USING THE TELEPHONE DURING AN ELECTRICAL STORM. THERE MAY BE A
REMOTE RISK OF ELECTRIC SHOCK FROM LIGHTNING.
11. DO NOT USE THE TELEPHONE TO REPORT A GAS LEAK IN THE VICINITY OF THE
LEAK.
IF YOUR PRODUCT USES BATTERIES, FOLLOW THESE ADDITIONAL PRECAUTIONS:
1. USE ONLY THE TYPE AND SIZE OF THE BATTERY SPECIFIED.
2. DO NOT DISPOSE OF BATTERIES IN A FIRE. THE BATTERIES CAN OR MAY EXPLODE.
CHECK LOCAL CODES FOR PROPER BATTERY DISPOSAL INSTRUCTIONS.
Teledex, LLC
6311 San Ignacio Avenue
San Jose, CA 95119
Telephone:
(408) 363-3100
Fax:
(408) 363-3136
email:
sales@teledex.com
Internet:
www.teledex.com
Copyright © 2002 Teledex LLC
All Rights Reserved.
Part Number: 600-0480-63
MAIN DIAGRAM
RIGHT VIEW
LEFT VIEW
WALL MOUNTING
Handset Volume
Speaker Volume
Handset Coil Cord
Handset Jack
Data Port
Cord Channel
Wall Jack
Wall Mount Clip
(under handset)
Handset
Ringer Volume
Data Port
Line Jack
Handset Volume
Mute Key
Redial Key
Flash Key
Speaker Volume
Store Key (hidden)
Guest Service Keys
Dial Pad
Speakerphone Key
Hold Key
Message Waiting Indicator
