Operator’s Manual
53
Applying Measurements
Any of the LabMaster measurements can also be applied to any of the OMA’s data outputs. There are 12
parameter slots available to use (P1 – P12). Measurements are added to a tabular display immediately
below the waveform grids.
Choose Measure > Measure Setup from the menu bar. Be sure to check Show Table to display the
measurement table, then open one of the parameter (Px) dialogs.
When selecting the parameter Source, navigate to the Main > OMA submenu and choose from the OMA
output traces and data. Back on the P
x
dialog, select the Measure(ment) as usual.
You may optionally show measurement statistics in addition to the acquired values, or plot
measurements over time using histograms, tracks, and trends.
Summary of Contents for IQS25
