P a g e
|
11
Use and disclosure shall be in accordance with the proprietary legend and DCS located on page i.
UG2243800-300
Sep 16, 2013
Revised Nov 12, 2013
Run Control
Run Control is a feature in the WQAR that prevents extraneous or non-
essential data from being recorded. Typically, the WQAR will record all data
sent to it by the Acquisition Unit. However, some aircraft manufacturers
(such as Airbus) or other Acquisition Unit manufacturers require the WQAR
to record only when commanded by the Acquisition Unit. With the
appropriate aircraft wiring in place, the Acquisition Unit can command the
WQAR to record. This concept is called Run Control.
When this feature is enabled, the WQAR will show Run Control status on the
front panel display (See Section 3). The WQAR can be set to one of three
modes:
Run Control
Mode
Description
0
Run Control Feature is not used. Flight Data is recorded
at all times.
1
Run Control Feature is used. Flight Data is recorded
when commanded by the Acquisition Unit.
2
Run Control Feature is used (Record in Air). Flight Data
is recorded only when the RF Interlocks are engaged.
This mode is enabled by a setting in the configuration files (OPC).
