4 Operation
Model 3010
PA
4-8: Part I
When you have finished typing the new password, press
Enter
. A
verification screen appears. The screen will prompt you to retype your
password for verification.
A A A A A
Retype PWD To Verify
Wait a moment. The entry screen will give you clearance to proceed.
A A A A A
<ENT> TO Proceed
Use the arrow keys to retype your password and press
Enter
when
finished. Your password will be stored in the microprocessor and the system
will immediately switch to the
Analyze
screen, and you now have access to
all instrument functions.
If no alarms are tripped, the
Analyze
screen appears as:
0.0 % AnlZ
Range: 0 100
If an alarm is tripped, the second line will change to show which alarm
it is:
0.0 % Anlz
A L 1
NOTE:If you previously logged off the system , you will now be
required to re-enter the password to gain access to Span,
Zero, Alarm, and Range functions.
4.3.4 Logout
The
Logout
function provides a convenient means of leaving the
analyzer in a password protected mode without having to shut the instrument
off. By entering
Logout
, you effectively log off the instrument leaving the
system protected against use until the password is reentered. To log out,
press the
System
button to enter the
System
function.
Contrast AutoCal
PSWD Logout More
Use the < > arrow keys to position the blinking over the
Logout
func-
tion, and press
Enter
to Log out. The screen will display the message:
Protected Until
Password Reentered
Contrast Function is
DISABLED
(Refer to Section 1.3)
Summary of Contents for 3010PA
