148
ProEM System Manual
Issue 3
C.1
ProEM:1600 Series with 3.60"/3.88" Bolt Circles
C.1.1
Assembly Instructions
1. Verify the shipping cover has been removed from the spectrograph’s camera port.
2. Loosen the two setscrews holding the sliding tube in the spectrograph
3. Rotate the sliding tube as you remove it from the spectrograph.
4. If the spacer plate is mounted to the sliding tube, remove the three (3) socket head
screws securing it to the tube.
5. Insert the three (3) 9/16" long pan head screws into the counterbored holes on the
sliding tube (as shown above) and through the matching holes on the spacer.
6. Position the sliding tube and spacer on the face of the camera and secure them to
the camera nose with the screws.
7. Rotate the camera and sliding tube assembly as you gently insert it into the
spectrograph.
8. Secure the sliding tube with the two setscrews.
NOTE:
Adapter parts are machined to provide a tight fit. If you need
to remove the sliding tube from the spectrograph, first
loosen the two setscrews that secure it, and then rotate the
tube as you pull it out. If you have removed the sliding tube
from the spectrograph, rotate the sliding tube as you
re-insert it, and tighten the setscrews afterwards to secure
it. Forcing the tube into the spectrograph may permanently
damage the tube and the spectrograph opening.
Item
Qty
P/N
Description
1
3
2826-0584
Screw, 10-32 x 9/16", Pan Head Phillips, Stainless Steel
Spacer Plate
Sliding Tube
(Tube and plate supplied with spectrometer)
Counterbored
Hole
4
4
11-
012
6
_0
100
Summary of Contents for ProEM Series
