N-Cycle/Gated
N-Cycle has specific number of waveform cycles, and every burst is activated
by a trigger event. Gated burst use external source to control burst as when to
be activated.
Figure 2- 47 Table 2- 24 Menu Explanations of the N-Cycle Parameters (Page2/2)
Cycles
Set the number of waveform cycle in an N-Cycle (1 to 50,000 or Infinite).
If you choose Infinite, then a continuous waveform will be generated which will
not stop until a trigger event happens.
If needed, Burst Period will increase to cater to the specific number
!
of cycles.
For an infinite-cycle burst, external or manual trigger is needed to
!
activate burst.
Function
Menu
Settings
Explanation
Cycles/
Infinite
Set the number of the bursts in a N-Cycle.
Set the number of the bursts in a N-Cycle to
be infinite.
Delay
Set the delay time before the burst starts.
Summary of Contents for SFG-20 Series
