Operation
Vision G2 Testers User Guide—74-108-800 Rev. H—12 June 2019
88 of 158
Events tab:
The Events tab allows the user to add events or modify the
Event Table.
The Event Table is a sequence of up to 50 events that will take
place at user-programmed times. There are two types of events,
sampling and remote commands. Sampling events must have
a time assigned to it. Remote command events may occur
during the test, pre-run (before the test), or post-run (after the
test).
NOTE: Pre-run and post-run events cannot be sampling events.
Pre-Run: Events programmed as a pre-run event will occur
before the test begins.
For example, an operator programs a pre-run event of Drive
Speed for 25 rpm. Prior to the test starting the motor will spin at
25 rpm. When the test begins, the motor will go to the speed
programmed on the Dissolution tab.
Post-Run: Events programmed as post-run will occur after the
test has completed.
For example, an operator programs a post-run event of Bath
Temp for 40 °C. Once the test completes, the bath temperature
will be set to 40 °C.
To edit or delete an event, touch the field in which it appears;
this will open the Edit Event screen.
Summary of Contents for VISION G2 CLASSIC 6
