ADR-7000 / SAVER-7000 / GUARD-7
© 2017
– Telefire Fire & Gas Detectors Ltd
Revision 0.98 October 2017
– Page 43 of 87 –
Switch (select All Modes; Reset Switch; Silence; Disconnect; Supervisory;
Abort; Release; Alarm Matrix; or Fan FC)
Power Supply
Sounder
Lamp
Extinguisher
Extinguisher Control
Control Output (select All Modes; Alarm; Fault; Fan; or Damper)
Isolator
CO / Heat Detector
Photo / Heat Detector
Supervisory Out
Fire Phone Jack
Fire Phone Lamp
SCM (select all modes; Fan / Damper; or Engage)
After selecting device type you can select the specific device address.
8.2.2 Enabling and Disabling a Zone
Selecting Operation by Zone shall display the following screen:
Screen 14 Enable / Disable Zone
This operation allows the disablement or enablement of devices in a specific logical
zone, rather than a physical loop. Device selection and criteria are identical to the
selection process by loop or address, as detailed in the previous paragraphs.
Screen 15 Enable / Disable Group
This operation allows the disablement or enablement of devices by group, rather than a
physical loop. Device selection and criteria are identical to the selection process by loop
or address, as detailed in the previous paragraphs.
