English
- 24 -
Installing the Batteries to the Remote
1.
Lift the cover on the back of the remote upward
gently.
2.
Install two AAA batteries. Make sure to match the +
and - ends of the batteries in the battery compartment
(observe the correct polarity.
3.
Replace the cover.
Connect Power & Antenna/Cable/Satellite
IMPORTANT:
The TV set is designed to operate on
220-240V AC, 50 Hz socket. After unpacking, allow
the TV set to reach the ambient room temperature
before you connect the set to the mains. Plug the
power cable to the mains socket outlet.
HDMI
1
HDMI
2
SPDIF
LNB
13V/18V
Aerial or Cable
Satellite
DiSEqC
Switch
Switching On/Off
To Switch the TV On
Connect the power cord to the 220-240V AC, 50 Hz.
Press
button. Then the standby LED lights up.
To switch on the TV from standby mode either:
Press the “
” button,
P+
/
P-
or a numeric button on
the remote control.
To Switch the TV Off
Press the “
” button on the remote control or press
the
button or hold the control switch on the Tv
until shut down, so the TV will switch to standby mode.
(Depends model)
To power down the TV completely, unplug the power
cord from the mains socket.
Note: When the TV is switched to standby mode, standby LED
can blink to indicate that features such as Standby Search,
Over Air Download or Timer is active. The LED can also blink
when you switch on the TV from standby mode.
First Time Installation
When turned on for the
fi
rst time, the “language
selection” menu appears. The message “
Welcome
please select your language!
” is displayed in all
language options listed alphabetically.
Press the “
” or “
” button to highlight the
required language, press
OK
button to select. “First
Time Installation” appears. Use “ ” or “ ” button
to set the required country, and press “
” button to
select “Teletext Language”. Use “ ” or “ ” button
to set the “Teletext Language” and select “Scan
Encrypted” using “
” or “
” button. You can set
Scan Encrypted
as
Yes
if you want to scan coded
stations.
You can activate Store Mode option by using left or
right button. If the Store Mode is set to “enabled”,
E-Pop option will be available in other settings menu. If
it is set to “disabled”, Store Mode will not be available
after the First Time Installation.
Note: If Store Mode is enabled, some features may be
affected.
Press
OK
button on the remote control to continue
and the following message will be displayed on the
screen.
02_MB80_[GB]_IDTV_TC_S2_BRONZE23_1910UK_32913W_10077883_50214472.indd 24
02_MB80_[GB]_IDTV_TC_S2_BRONZE23_1910UK_32913W_10077883_50214472.indd 24
29.02.2012 14:27:22
29.02.2012 14:27:22
