English
- 31 -
Installing the Batteries to the Remote
1.
Lift the cover on the back of the remote upward
gently.
2.
Install two AAA batteries. Make sure to match the +
and - ends of the batteries in the battery compartment
(observe the correct polarity.
3.
Replace the cover.
Connect Power & Antenna/Cable/Satellite
IMPORTANT:
The TV set is designed to operate on
220-240V AC, 50 Hz socket. After unpacking, allow
the TV set to reach the ambient room temperature
before you connect the set to the mains. Plug the
power cable to the mains socket outlet.
SPDIF
VGA
13V dc /18V dc
3
00mAMax.
12V
Aerial or Cable
Satellite
DiSEqC
Switch
Switching On/Off
To Switch the TV On
Connect the power cord to the 220-240V AC, 50 Hz.
Then the standby LED lights up.
To switch on the TV from standby mode either:
Press the “ ” button,
CH ^/ v
or a numeric button on
the remote control.
Press the control switch located on the left side of the
TV. The TV will then switch on.
To Switch the TV Off
Press the “ ” button on the remote control or press and
hold the control switch on the TV, so the TV will switch
to standby mode.
To power down the TV completely, unplug the
power cord from the mains socket.
Note:
When the TV is switched to standby mode,
standby LED can blink to indicate that features such
as Standby Search, Over Air Download or Timer is
active. The LED can also blink when you switch on
the TV from standby mode.
First Time Installation
When turned on for the first time, the “language
selection” menu appears. The message “
Welcome
please select your language!
” is displayed in all
language options listed alphabetically.
Press the “
” or “
” button to highlight the required
language, press
OK
button to select. “First Time
Installation” appears. Use “ ” or “ ” button to set
the required country, and press “
” button to select
Search Type (Optional). Use “ ” or “ ” to set the
desired search type. Available search types are Digital
and analog, digital only and analog only. When set, press
“
” to select Teletext Language. Use “ ” or “ ”
button to set the “Teletext Language” and select “Scan
Encrypted” using “
” or “
” button. You can set
Scan
Encrypted
as
Yes
if you want to scan coded stations.
Press
OK
button on the remote control to continue and
the following message will be displayed on the screen.
You can activate Store mode option by using “ ” or “ ”
button. If Store Mode is selected, Store mode option
will be available in other settings menu and your
TV’s features will be illustrated on the top of the
screen.A confirmation screen will be displayed after
selecting the Store Mode. Select
YES
to proceed.
