English
- 75 -
Inserting Batteries into the
Remote Control
• Remove the battery cover located on the back of
the remote control by gently pulling backwards from
the indicated part.
• Insert two
AAA/R3
or equivalent type batteries
inside. Place the batteries in the right directions and
replace the battery cover.
Note
: Remove the battery from remote control when it is not
to be used for a long period. Otherwise it can be damaged
due to any leakage of batteries.
Switching the TV On/Off
To Switch the TV On
Your TV will switch on in two steps:
• Connect the power cord to the system.
• Press standby On/Off button. Then the standby
LED lights up.
• To switch on the TV from standby mode either:
• Press the “ ” button,
P+
/
P-
or a numeric button
on the remote control or press the
-P/CH
or
P/CH+
button on the TV. The TV will then switch on.
Note
: If you switch on your TV via PROGRAMME UP/DOWN
buttons on the remote control or on the TV set, the programme
that you were watching last will be reselected.
By either method the TV will switch on.
To Switch the TV Off
• Press the “
” button on the remote control or press
the standby On/Off button, so the TV will switch to
standby mode.
Note: If you have switched off the TV set from the Standby
On/Off button instead of remote control, next time you press
the Standby On/Off button, the TV set will switch on without
going to the standby mode.
• To power down the TV completely, unplug the
power cord from the mains.
Input Selection
Once you have connected external systems to your
TV, you can switch to different input sources.
• Press “
” button on your remote control for directly
changing sources.
or
• Select “
Source
” option from the main menu
by using “ ” or “ ” button. Use then “
” or
“ ” button to highlight an input and press “
” button
to select.
Note
: With the
“ ” or “
”
buttons you can set Off or On.
When Off is selected; this source does not appear in the
OSD when you press the
“
”
button of the remote control.
(except for the TV source).
Note
: YPbPr mode can be used only when you connect a
device that has a YPbPr output through the PC-VGA input with
YPbPr to PC cable (YPbPr cable is not supplied).
Basic Operations
You can operate your TV using both the
remote control and onset buttons.
Operation with the Buttons of the TV
Main menu OSD cannot be displayed via control
buttons. “
+/-
” buttons will function as volume up/down
as default. Even if you set other functions for these
buttons, “
+/-
” buttons will perform as default after a
short while.
Volume Setting
• Press “
+/-
” buttons to increase or decrease volume,
so a volume level scale (slider) will be displayed
on the screen.
Programme Selection
• Press P/V/AV button once and then use “
+/-”
buttons
to select the next or previous programme.
AV Mode
• Hold the
“P/V/AV”
button, source OSD will be
displayed.Use
“+/-”
buttons to select the desired
source.
Summary of Contents for TFX 1646 D 857U
Page 98: ...50170563...
