INTRODUCTION
INSTALLATION
CAUTION
Locate the receiver in the room where direct light does not strike the screen.
Total darkness or a reflection on the picture screen can cause eyestrain.
Allow enough space between the receiver and the wall to permit ventilation.
Avoid excessively warm locations to prevent possible damage to the cabinet or premature component
failure.
This TV receiver can be connected to AC 220-240 Volts. 50/60 Hz. Never connect to DC supply or any
other power supply.
Do not install the receiver in a location near heat sources such as radiator, air ducts, direct sunlight, or in
a place somewhere like close compartment and close area.
Do not cover the ventilation openings when using the set.
Soft and indirect lighting is
recommended for comfortable viewing.
Never tamper with any components inside your set, or any other adjustment controls not mentioned in
this manual. All television receivers are high voltage instruments. Your PICTURE TUBE is highly evacuated.
Scratching, chipping or undue pressure is dangerous and should be avoided. To clean, the power cord
should be pulled out from the plug receptacle, then wipe the receiver with a dry soft cloth. During thunder
and lightning storms, unplug the power cord and antenna cord to prevent your TV set from damage.
-2-
Thank you for purchasing this television. To get the most out of this unit please carefully read the
instructions and keep them in a safe place for future reference.
Summary of Contents for TTV-29N02
Page 18: ......